|
Overview
The Model 730 is a 48 V, 7.2 Ah Battery
Module with current overload protection and visual CHARGE and DISCHARGE
LED status indicators. Rechargeable batteries contained within the Model
730 provide output battery backup capability in the event of an AC input
voltage interruption to the external charging power supply. The Model 730
will continue to supply a 2 A DC output for up to nominally three hours.
For output loads of less than 2 A the battery operating time will
substantially increase. The unit is completely self-contained in a
compact enclosure. Mounting kits, available separately, allow the unit
to be wall or rack mounted. The Model 730 is Underwriters Laboratories,
Inc. LISTED under their UL-60950 category.
Model 730 Specifications
DC Input Voltage:
54.5 Vdc to 55.2 Vdc Trickle Charge Method
58.0 Vdc to 59.6 Vdc Cycle Charge Method
Max Input
Current:
1.08 A, maximum with Trickle Charge Method
2.80 A, maximum with Cycle Charge Method
Output
Voltage:
48 Vdc, nominal, battery operation
Output Current: 2.0 A continuous, maximum
Output Protection:
Type: solid-state, automatic reset
Current required for automatic output shutoff: 3.5 A, nominal
Batteries:
4
Type: 12 V, 7.2 Ah, sealed lead-acid
Transportation: classed as "Non-Spillable”
Battery Operating Time (Nominal):
3 hours, 2.00 A output load
5 hours, 1.20 A output load
10 hours, 0.60 A output load
20 hours, 0.30 A output load
Battery Charge Time (Nominal):
24 hours, 0.65 A
6 hours, 1.30 A
3 hours, 2.60 A
Figures reflect charging process beginning with batteries in fully
discharged state
Automatic
Battery Disconnect:
to prevent deep discharge to the batteries the connected equipment must
provide a nominal 41 V low voltage cut out
Output Connectors: 1
Functions Supported: ground and DC battery output
Type: Molex® Mini-Fit, Jr.™ 6-position dual-row header
Mating Connector: Molex Mini-Fit, Jr. 6-position dual-row receptacle,
suggested Molex part number 39-01-2060; suggested crimp-on female
terminals Molex part number 39-00-0039
Interconnecting Cables:
One interconnecting cable required for every installation; purchased
separately, not included with Model 730. Various lengths and
configurations available from Gordon Kapes, Inc.
Battery Status LED Indicators: 2
Functions: CHARGE, DISCHARGE
Safety Compliance: Underwriters
Laboratories, Inc. UL-60950 LISTED
Radiated Noise Compliance: complies with
FCC Part 15, subpart J, class A for radiated and conducted emission
Operating Environment:
68 degrees F (20 degrees C), nominal. Intended for operation in
commercial environment where air conditioning is present. Operation at
temperatures greater than recommended will significantly reduce battery
life.
Dimensions (Overall):
2.9 inches high (7.4 cm)
17.0 inches wide (43.2 cm)
9.1 inches deep (23.1 cm)
Figures reflect no mounting brackets attached
Mounting:
Wall, 19-inch rack, or 23-inch rack mounting kits available, purchased
separately. A mounting kit is required for every installation; not
included with Model 730.
Weight:
32.7 pounds (14.9 kg)
35.2 pounds (16.0 kg), shipping weight
Figures reflect no mounting brackets attached
Specifications
subject to change without notice.
|
